日本代购-商品情報商品の説明OLED Switch card reader comes with both game card reader and Micro SD card reader. It’s a direct replacement for Nintendo Switch OLED. It includes 2x card cartridges, flex connectors and the 3.5mm audio AUX port for headphones. All the necessary repair tools are included in the box. Works with Switch OLED model ?HEG-001 [For Problems List]: Game card not detected, No reading the games, Re-loading the game now and then, or you cannot insert and retract the game card into/from the slot. In many cases, you might notice one or two inner prongs are not aligned. Make sure your original reader is the problem before ordering [DIY Reminder]: 1. Not for Switch ?HAC-001 or Switch Lite ?HDH-001. Check the model num. of your console before ordering 2. You have to take the Switch apart to have it replaced. It’s a ‘plug and play’ DIY, no soldering needed 3. No instruction included, please study the video demonstration online [Packaging]: 1x Replacement Card Reader (Switch OLED HEG-001) 1x Y00 Tri-wing Screwdriver 1x PH000 Cross Screwdriver 1x Plastic Opening Pry Tool 1x Tweezer主な仕様 [ゲームカードリーダー交換用Switch有機ELモデル] − ゲームカードリーダーとMicro SDカードスロットの両方が1つの回路基板に統合されています。 Switch OLEDの直接の代替品です。カード カートリッジ x 2、フレックス ケーブル コネクタ、ヘッドフォン用の 3.5 mm オーディオ AUX ポートが含まれています。必要な修理ツールはすべて箱の中に含まれています。 Switch OLEDモデル?HEG-001で動作します。 Switch ?HAC-001 または Switch Lite ?HDH-001 には対応しません。br[問題リストの場合] − ゲームカードが検出されない、ゲームを読み込まない、ゲームを時々再ロードする、またはゲームカードをスロットに挿入したり取り出したりできない。多くの場合、1 つまたは 2 つの内側の突起が揃っていないことに気づくかもしれません。注文する前に、元のリーダーに問題があることを確認してくださいbr[DIY リマインダー] − 1. 交換するにはスイッチを分解する必要があります。これは「プラグアンドプレイ」DIYであり、はんだ付けは必要ありません。 2. ご注文前に、本体のモデル番号をご確認ください。説明書は含まれていません。オンラインでビデオデモをご覧ください。